Newest DSP CO2 Laser Cutting Engraving LCD Motion Controller System MPC6525

  

Newest DSP CO2 Laser Cutting Engraving LCD Motion Controller System MPC6525. Brand New, High Quality and Extra Long Life. Advanced stand-alone 3-axis motion controller designed for laser engraving and cutting applications. Incorporating the advanced Field Programmable Gate Array (FPGA) and a 32-bit DSP, MPC6515 provides dedicated motion control features. Apply DSP and FPGA technologies.

3-axis card for stepper motors or digital servo motors. Trapezoidal or S-curve drive of slow-up/slow down control. Switch interfaces such as origin and limit. 1-CH laser power on/off control output.

1-CH laser PWM control output. Support 1or 2-CH independent power analog output. RS232 applicable for mainstream industrial touchscreen supporting Modbus communication protocol. Download data with USB flash disk or USB data cable. USB transfer speed up to 500Kb/s.

Look-ahead algorithm and trajectory fitting algorithm. Operation panel with English interface.

Pluggable terminal blocks of MPC6515 make the connection easier for users. All I/Os are optically isolated signals. USB flash disk instruction light. X1: Input power interface (24VDC) Note: MPC6515 adopts mono 24VDC power supply. The other power pins are output. Note: JP1 is related with X3, X4 and X5. If 24V voltage is required for input signal ports X3, X4 and X5, the jumper should be connected to Pin1 and Pin2.

If 5V voltage is required, the jumper should be connected to Pin2 and Pin3. If the jumper is removed, disconnect Pin5 of X3, X4 and X5. JP2: Note: JP2 is related with Y2. For analog-control laser power, remove the jumper, connect laser power to Pin2.

For PWM-control laser power, connect the power to Pin3. JP3: Note: JP3 is related with Y1. If output Y1 to drive a 24V relay, the jumper should be connected to Pin1 and Pin2. To drive a 5V relay, the jumper should be connected to Pin2 and Pin3. If the jumper is removed, disconnect Pin6 of Y1.

JP4: Note: JP4 is related with X2. If 24V is required for the general input X2, the jumper should be connected to Pin1 and Pin2. If the jumper is removed, disconnect Pin5 of X2.

Limit and Origin switches applied with MPC6515 can be contact switch or NPN proximity sensor. Digital outputs of MPC6515 can drive intermediate relay or photo coupler. Refer to the following wiring diagram.

Stepper motor drives or digital servo motor drives receive Pulse/Direction outputs generated from MPC6515. Refer to following wiring diagram of Pulse/Direction signals. Return must in original package and not been used. The item "Newest DSP CO2 Laser Cutting Engraving LCD Motion Controller System MPC6525" is in sale since Tuesday, June 11, 2013.

This item is in the category "Computers/Tablets & Networking\Printers, Scanners & Supplies\Printers". The seller is "win-win-mechatronic" and is located in ShangHai. This item can be shipped worldwide.

1. Brand: lettro
2. MPN: 6525
3. UPC: Does not apply